![]() And, yes, I know I can use VueScan, but it's an extra $90 and I want to try also the original software. Threats include any threat of suicide, violence, or harm to another. I do have the driver, just not the scanning software. Harassment is any behavior intended to disturb or upset a person or group of people. If anyone reads this and happens to have time to open theirs, could you measure the voltage out from the 7812?Īlso, I lost the Dimage scan CD. still I'm concerned about just putting 12V on a board. I don't think any 78xx chip outputs 2.2V, and even if it were, would not be market 7812, methinks. The right pins are connected to GND and +23V, and the output is a lower voltage (albeit the wrong one). While I find strange that the scanner uses a 12V rail, I cannot see what else that SMD chip could be if not a 7812 voltage regulator. I found a 7812 chip that looks like a 12V voltage regulator, but the output is only 2.2V, even when lifting the output from the PCB (I was checking to see if the problem was with the regulator or the circuit following it). ![]() Konica Minolta DiMAGE Scan Elite 5400 II Review at Imaging Resource. I'm also trying to repair a Dimage Elite 5400 II (the new model, the one with a LED light not CFL) In addition, Vuescan no longer needs a WIA driver on Windows or an ICA driver on Mac.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |